TECH tech-obd scanner

The TECH-OBD scanner enables communication between the TECH gas injection system and the petrol ECU using the OBD II diagnostic interface. The distinguishing feature of Scanner TECH-OBD is the ability to use it as an independent OBD reader, thanks to which, in addition to reading corrections and errors, you can check the vehicle operating parameters provided by the OBD driver.
The TECH-OBD scanner in conjunction with the TECH-124, TECH-224 and TECH-320 series controllers gives you the option of setting automatic error reset (up to eight errors) - automatically removes errors previously entered in the table. In the case of other irregularities, the reset will not take place so that the "check engine" light on alerts the driver to check the engine system.
Scanner TECH-OBD, after connecting with the appropriate TECH controller and the vehicle's diagnostic system, collects maps of injection time correction values on petrol and gas. After turning on the adaptation, the OBD system automatically modifies the composition of the mixture so that the deviations between the maps are reduced to zero, i.e. to the ideal setting of the car.

The set includes a scanner with a wiring harness for LpgTech installations, a necessary diagnostic interface. It is possible to use the device as a diagnostic tool after purchasing a service cable (00.LPG.301) connected to the standard OBD connector (16-pin).

Supported Protocols:

• ISO 15765-4 CAN (11 bit ID, 500 Kbaud); ISO 15765-4 CAN (29 bit ID, 500 Kbaud);
• ISO 15765-4 CAN (11 bit ID, 250 Kbaud); ISO 15765-4 CAN (29 bit ID, 250 Kbaud);
• ISO 14230-4 KWP (fast init, 10.4 Kbaud); ISO 14230-4 KWP (5 baud init, 10.4 K baud);
• ISO 9141-2 (5baud init, 10.4Kbaud);
• SAE J1850 VPW (10.4Kbaud); SAE J1850 PWM (41.6Kbaud);